Weller PYROPEN Piezo Instrucciones Para El Manejo página 16

3. HOW TO USE THE SOLDERING TIP
1.
Be sure the hot air exhaust opening is
positioned upward, as illustrated. Keep
hands and combustibles clear of exhaust
opening to avoid burns or fire.
3.
Push ignition button slowly and hold
three seconds after it clicks.
5.
Adjust tip temperatur with gas control
lever.
4. HOW TO USE AS TORCH
To remove the soldering tip and tip
receptacle, undo the knurled nut.
15
E
Replace the soldering tip with the hot air nozzle.
The ignition system is the same as for the
soldering iron.
2.
Set control lever to "2". Set gas ON/OFF
lever to "ON" position. In cold tempera-
tures or immediately after gas filling set
lever higher than "2".
4.
Wait until the window becomes red, then
release button slowly. If it fails to ignite,
repeat ignition process outlined under
stip 3 above.
6.
To turn off, slide the gas ON/OFF lever to
"OFF" position until it clicks. (Control
lever does not turn off).