Configuring The Datalogger Function - Promax PROLINK-4C Manual De Instrucciones

4.9.4.4.1

Configuring the Datalogger Function.

The configuration menu of the Datalogger function allows you to choose
between taking and/or printing measurements, programming the PROLINK-4C to take
measurements at a pre-determined time, defining the time interval between
measurements, erasing all measurements stored in the Datalogger function, and
automatically deactivating all the measurement configurations.
To define the configuration of the Datalogger function press key
repeatedly until you have selected the Config field and then press the rotary selector
[4]. The configuration screen of the Datalogger function will then appear.
Figure 31.- Configuration of the DATALOGGER function
After an interval of half a minute without the PROLINK-4C controls being
touched, it will automatically return to the Datalogger function main screen.
1.- TO MEASURE, PRINT OR MEASURE AND PRINT?
First of all, the user must indicate whether he wants to take measurements or to
print them, or to do both at the same time. To do this, press the
repeatedly until positioned in the Measure field. Then turn the rotary selector [4] to
activate (On) or deactivate (Off) the measurement function and press
The next step is to activate or deactivate the measurement printing function. To do this,
use the key [31] to position the cursor in the Print field and activate it (On) or
deactivate it (Off) turning the rotary selector [4] and pressing it validate the new state.
Page 62
USER'S MANUAL. PROLINK-4C
[31]
[31] key
[31] key.
02/2003