Diagnostic Display; Error Description; Entering And Leaving - B+B Neo XXL Manual De Instrucciones

Neo XXL
| Electric Wheelchair

4.1.5. Diagnostic Display

If the control unit detects an error in the system while the wheelchair is
in use, the diagnostic display automatically appears.
An error code, a short description of the error and the module where
the error occurred are then shown in the display.
Identified Module

Error description

43
Identified modules
PM Power Module
JSM Joystick Module
ISM Intelligent Seating/Lighting Modul
Error description
The text gives a short description of the error type.
Error code
The 4-digit code indicates the exact error which has been detected.
Diagnostic Procedure
Proceed as follows:
• Read the error description, identify the module and the exact error
code.
• Switch the controller off.
• Check the connections to the modules.
• Check the battery charge level.
• Carry out the action for the error code, as it is described in the
service guide (available from your authorised service engineer).
68
• Switch the wheelchair back on and check it is functioning properly.
If the wheelchair does not function in the usual way, switch it off
again and contact your service engineer.

4.2. Entering and leaving

Entering and leaving from the side
• Move the wheelchair as close as possible to the present or future
seat so they are side by side.
• If you wish to move from another wheelchair or room chair, lock it
by setting the parking brakes.
Error code
• Lock the Neo to prevent it from moving accidentally by pressing the
On/Off button to switch off the control (all displays off).
• Remove the arm rest and side section.
• Fold the foot plates to the side or remove the leg rests.
• Now slide sideways onto the other seat.
• Make sure that you are sitting as far back in the seat as possible.
• Move the arm rest and leg rests to the original position
Entering and leaving from the front
• First fold the foot plates up or remove the leg rests.
• Move the Neo XXL as close as possible to the present or future seat
front to front
• If you wish to move from another wheelchair or room chair, lock it
by setting the parking brakes.
• Lock the Neo to prevent it from moving accidentally by pressing the
On/Off button to switch off the control (all displays off)
• Now slide onto the seat by turning your body around.
• Then move the arm rest and leg rests to the original position
Bischoff & Bischoff GmbH | 01.06.2019
Neo XXL
Electric Wheelchair |
69