Neo XXL
| Electric Wheelchair
3.5. Basic Settings
It is necessary to adjust the wheelchair to your body size before first use.
This is the only way to ensure a physiologically correct posture allowing
for long drives without tiring. Below you find a description of the basic
settings of the wheelchair. You should carry out these adjustments with
the help of your medical supply dealer. You need a set of 4,5mm and
6 mm Allen keys, a screw driver and ring spanners, 10 and 13 mm.
3.5.1. Leg Supports
Length of lower leg supports
•
The lower leg supports can be adjusted from 355 - 425 mm
•
To do this, loosen the screw joint and pull the screw out.
•
Adjust to the desired height. (Fig. 02).
•
Re-insert the screw and tighten the screw joint up again.
02
02
Angle of footrest
•
Loosen the screw joint on the side of the footrest.
•
Set the required angle of the footrest (fig. 03).
•
Re-tighten the screw. To fix it in place, use Loctite 243
03
03
54
Make sure to always use two screws for secure
fastening!
Electric Wheelchair |
Knee angle
•
The angle of the legrests can be set via a perforated plate.
•
Loosen the red locking clip on the inside and pull the pin out.
•
Move the legrest into the required position (fig. 04).
•
To fix it in place, the pin is re-inserted and secured using the
locking clip
Make sure to set the angle only within the marked
range.
•
3.5.2. Seat
Seat depth
The seat depth can be altered from 420 to 510 mm..
•
First remove the seat cushion.
•
Loosen the screw joint and move the seat plate into the required
position (fig. 05).
•
Re-tighten the screws.
Seat width
•
The seat width is set by lateral adjustment of the side parts.
•
Loosen the screw joint and remove the memory stick.
•
Move the side bar into the required position (fig. 06).
•
Re-insert the memory stick and tighten the screw joint up again
Make sure that both memory sticks, on the right
and left, are located in the same hole position!
Bischoff & Bischoff GmbH | 01.06.2019
Neo XXL
04
05
06
55