Basic Settings; Mechanical Footrests - B+B Taiga Manual De Instrucciones

Taiga
| Electric Wheelchair
3.4. Summary
push handles
backrest
R-Net controller
seat cushion
Electrical leg rests
Kerb climber
Fully electrical
VR-2 controller
arm rest
side part
Front light
Rear reflectors
Mechanical leg rests
drive wheels
steering wheel
Standard configuration
54

3.5. Basic settings

It is necessary to adjust the wheelchair to your body size before first
use. This is the only way to ensure a physiologically correct posture
allowing for long drives without tiring. Below you find a description
of the basic settings of the wheelchair. You should carry out these
adjustments with the help of your medical supply dealer. You need a
set of 5 mm to 8 mm Allen keys.

3.5.1. Mechanical footrests

Length of lower leg supports
• The lower leg supports can be adjusted from 470 to 550 mm.
• To do so, loosen the two Allen screws (fig. 03).
• Adjust to the desired height.
• Tighten the screws again. Use medium-strength Loctite for fixation.
Make sure to always use two screws for secure
fastening!
Angle of footrest
• The angle of the footrests is adjustable in 25° steps.
• Loosen the screwing at the side of the footrest.
• Adjust to the desired angle.
• Tighten the screw again. Use medium-strength Loctite for fixation.
02
Bischoff & Bischoff GmbH | 01.06.2019
Taiga
Electric Wheelchair |
03
04
55