Delay Start - Kenmore 911.47822 Instrucciones De Uso Y Cuidados

CARE ANDCLEANING
Self-Cleaning Cycle
The Clean Cycle, including cooldown
time, is automatically set for 4 hours,
but you may change this from 3 hours
if oven is lightly soiled, up to 5 hours if
oven is heavily soiled.
(_ 1. Press the CLEAN
pad. 4 hours will
show in the display.
@@
HOUR MIN
2. If you want to
change the length of
clean time press the
HOUR/MIN UP and/
or DOWN arrow
pad.
3. Press the START pad,
The door locks automatically The
display will show the clean time
remaining. It will not be possible to
open the oven door until the
temperature drops below the lock
temperature and the LOCKED light
goes off. When the LOCKED light is
off, open the door. The words LOCKED
will flash and the oven control will
signal if you set the clean cycle and
forget to close the oven door
Simply press the CLEAR/OFF pad.
You will need to wait for the oven
temperature to drop below the lock
temperature (approx. 1 hour) before
attempting to open the door.
After the cycle, you may notice some
white ash in the oven. Just wipe it up
with a damp cloth or sponge.
If white spots remain, scrub them with
a soap-filled steel wool pad. Be sure
to rinse thoroughly. These are usually
deposits of salt that cannot be
removed during the cycle.
If your oven is equipped with
porcelain oven racks, it will be
necessary to grease the edges with a
light coating of vegetable oil after the
clean cycle. This will help maintain
the ease of sliding the racks in and
out of the oven.
If for any reason you are not
satisfied with the cleaning results,
just repeat the cycle,
1, Press the CLEAN
pad.
@@
HOUR MIN
HOUR MIN
@@
2. If you want to
change the length
of clean time press
the HOUR/MIN UP
and/or DOWN arrow
pads.
3, Press the TIME
DELAY START
pad.
4. Press the HOUR/
MIN UP and/or
DOWN arrow pads
to set the time you
prefer the clean
cycle to start.
5. Press the START pad.
21