Storing The Machine; Taking Care Of The Guide Bar - Stihl GS 461 Manual De Instrucciones

Storing the Machine

If the machine is to remain out of use for
approx. 3 months or more
Drain and clean the fuel tank in a
N
well ventilated place
Dispose of fuel in accordance with
N
the regulations and having regard
for the environment
Run the engine until the carburetor
N
is dry, this helps to prevent the
carburetor diaphragms sticking
together
Remove, clean and dry diamond
N
abrasive chain and guide bar, and
spray with STIHL multispray – in
particular the bearing of the
sprocket nose – corrosion
protection.
Thoroughly clean the machine - pay
N
special attention to the cylinder fins
and air filter
Store machine in a safe and dry
N
place. Protect against unauthorized
use (e. g., by children)
GS 461

Taking Care of the Guide Bar

2
1
Flip the guide bar – each time the
N
chain is changed – to avoid uneven
wear, especially at the sprocket
nose and on the bottom
Periodically clean the water inlet
N
hole (1), water outlet channel (2)
and bar groove (3)
Measure groove depth – using the
N
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
If the groove is not at least
0.24" (6.0 mm) deep:
Replace guide bar
N
Otherwise the drive links will grind
against the base of the groove – tie
straps will not lie against the bar.
If the guide bar runs in the cut:
Check guide bar for uneven wear
N
(ridge offset)
Flip the guide bar, if necessary
N
remove the bore of the guide bar
with guide bar straightener
3
English
31