Switching On; Trigger Switch; Switching Off - Stihl HSA 65 Manual De Instrucciones

English

Switching On

The battery is given a charge of about
30% before leaving the factory.
It must be fully charged before you use
the power tool for the first time.
Fitting the rechargeable battery
1
N Insert the battery (1) in the power
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching On
N Make sure you have a secure and
balanced footing.
N Stand upright – hold the power tool
in a relaxed position.
N
Make sure the cutting attachment is
not touching the ground or any other
objects.
N Hold the unit with both hands – one
hand on the control handle – one
hand on the loop handle.
16
2
N Unlock the power tool by moving the
retaining latch (2) to ‚.
3
4
5
N Push the switch lever (3) against
the loop handle and hold it there.
N Push down the trigger switch
lockout (4) and depress the trigger
switch (5) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the switch
lever (3), trigger switch lockout (4) and
trigger switch (5) are operated
simultaneously.

Trigger switch

Motor speed is controlled with the trigger
switch. Depress the trigger switch to
accelerate the motor.

Switching Off

1
N Release the switch lever (1) and the
trigger switch (2).
3
4
N Move the retaining latch (3) to ƒ –
the trigger switch (4) cannot be
operated – the power tool is locked
to prevent start-up.
Always remove the battery from the
power tool during work breaks and after
finishing work.
HSA 65