Mounting Of Handle - Makita EM4250 Manual De Instrucciones

MOUNTING OF HANDLE

CAUTION: Before doing any work on the brush cutter, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
For machines with U Handle models
– Insert the handle bar into the handle holder, making sure that the boss in the
handle holder fits into the hole in the handle.
– After the handle bar is in place, tighten the four bolts (M5 x 25).
NOTE: Be sue the bolts are tight, but do not overtighten.
– Fit the control cable (together with the earth cord) to the handle with two
clips (3).
– Avoid any tendency of the control cable to loop at the handle bar.
For machines with Loop Handle
– Fix a barrier to the left side of the machine together with the handle for
operator protection.
– Make sure that the grip/barrier assembly is fitted between the spacer and the
arrow mark.
WARNING: Do not remove or shrink the spacer. The spacer keeps a certain
distance between both hands. Setting the grip/barrier assembly
close to the other grip beyond the length of the spacer may cause
loss of control and serious personal injury.
(3)
to engine
9
Arrow mark