Maintenance; General Maintenance - Ryobi YN301PL Manual Del Operador

 Any continued loss of air after performing the above steps
indicates a problem with the safety valve. Discontinue
use and seek service before continued use of the air
compressor.
WARNiNG:
When servicing use only identical Ryobi
parts. Use of any other parts may create a hazard or
cause product damage.
WARNiNG:
Always wear eye protection marked to comply with ANSI
Z87.1 during maintenance. If operation is dusty, also
wear a dust mask.
WARNiNG:
Always release all pressure, disconnect from power
supply, and allow unit to cool to the touch before cleaning
or making repairs on the air compressor.

GENERAL MAiNTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: FiGURES (iLLUSTRATiONS) START ON PAGE 16
AFTER SPANiSH LANGUAGE SECTiON.
OPERATiON
If air leaks after the ring has been released or if the valve is
stuck and cannot be actuated by the ring, do not use the
air compressor until the safety valve has been replaced.
Use of the air compressor in this condition could result
in serious personal injury.

MAiNTENANCE

replacement
Do not at any time let brake fluids, gasoline, petroleum-
®
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently, we
do not recommend using this product for extended work
on these types of materials. However, if you do work with
any of these materials, it is extremely important to clean
the product using compressed air.
LUBRiCATiON
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no further
lubrication is required.
14 - English
WARNiNG:
WARNiNG: