Ubermann UCS04BRA Manual Del Operador página 43

FEATURES
PRODUCT SPECIFICATIONS
Blade Diameter..........................................................................6-1/2 in.
Blade Arbor .................................................................................. 5/8 in.
Cutting Depth at 0º ................................................................. 2-1/8 in.
ASSEMBLY
Unpacking
This product requires assembly.
• Carefully remove the tool and any accessories from the box.
Make sure that all items listed in the packing list are included.
WARNING:
Items in this Assembly section are not assembled to the product
by the manufacturer and require customer installation. Use of a
product that may have been improperly assembled could result
in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product
until the parts are replaced. Use of this product with damaged
or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not
recommended for use with this product. Any such alteration or
modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
Cutting Depth at 45º ............................................................... 1-5/8 in.
No Load Speed .......................................................5,000 r/min. (RPM)
Motor ..................................................................................... 20 Volt DC
Attaching the Blade
See Figure 1, page 19.
WARNING:
A 6-1/2 in. blade is the maximum blade capacity of the saw. Never
use a blade that is too thick to allow outer blade washer to
engage with the flats on the spindle. Larger blades will come in
contact with the blade guard, while thicker blades will prevent
blade screw from securing blade on spindle. Either of these
situations could result in a serious accident.
• Remove the battery pack from the tool.
• Remove the blade wrench (5 mm hex key) from the storage
area.
• Depress the spindle lock button and remove the blade screw
and outer blade washer.
NOTE: Turn the blade screw counterclockwise to remove.
NOTICE:
To prevent damage to the spindle or spindle lock, always allow
motor to come to a complete stop before engaging spindle lock.
NOTE: Do not run the circular saw with spindle lock engaged.
• Wipe a drop of oil onto the inner blade washer and outer blade
washer where they contact the blade.
9 — English