Declaration Of Conformity - VITO PRO-POWER VIGD5SH Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

EN
X. STORAGE
If store the generator for long
periods, make the following
preparations:
- Operate the engine for about 3
minutes and then stop.
- Stop the engine.
- Drain the engine oil while the
engine is still warm and fill with
new oil.
XI.TROUBLESHOOTING
Fuel is not suficiente
Speed control lever in the "OFF" position
Fuel injection pump and nozzle do not deliver
the fuel or deliver insufficient fuel quantity
Engine
doesn't start
Lack of engine oil
The nozzle is dirty
The battery is not charged
Main switch is not turned on
El gen-
Carbon brush already worn
erador no
The contact of the socket is not good
proporciona
AVR is damaged
electricidad
Rated speed can not be reached
*
(
) - Special tools are required. Please contact with our agent VITO.
DECLARATION
OF CONFORMITY
We declare under our exclusive
responsibility, that the product
Meets the following standards or
standardization documents:
EN 60825; EN 12601 according to
the determinations of the directives:
2006/42/EC - Machinery
Directive;
2014/35/EC - Low Voltage
Directive;
2000/14/EC - Sound power level
guaranteed: LwA: 96 dB(A)
- Sound power level mesured: LpA
72 dB(A).
- Turn the engine 2-3 seconds with
the decompression lever set at the
non-com-pression position, and the
starting key at the "START" position
(Do not start the engine).
- Wipe off the oil and dirt from the
engine and store in a dry place.
Fault cause
WARRANTY
CERTIFICATION
The warranty of this compressor
is two years from the date of
purchase. You should, therefore,
keep your proof of purchase during
this period of time. The warranty
covers any manufacturing defect
in material or operating, as well
Remedy
Refill the fuel
Turn it to "START" position
Remove the nozzle and repair it at test table
The oil level should be between
the minimum and maximum positions
Clean the nozzle
Charge it or replace it
Turn the main switch to "ON" position
Replace the carbon brush
Adjust the socket
Replace it
Adjust it according to the requirements
as parts and work needed for
their recovery.Excluded from
the warranty the misuse of the
product, any repairs carried out by
unauthorized persons (outside the
service center of the brand VITO)
as well as any damage caused
by the use of it.
31
Tabla de contenido
loading

Tabla de contenido