Voice Operated Transmission (Vox) - Kenwood NEXEDGE NX-240 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

VOICE OPERATED TRANSMISSION (VOX)

VOX operation allows you to transmit hands-free. This feature
must fi rst be activated by your dealer, and can only be used if
you are using a supported headset. VOX can be turned off for
specifi c channels by your dealer. To activate VOX and set the
VOX Gain level, perform the following steps:
1 Connect a headset to the transceiver.
The VOX function does not activate when a headset is not
connected to the accessory terminal of the transceiver.
2 With the transceiver power OFF, press and hold the Side 1
key while turning the transceiver power ON.
3 Continue to hold the Side 1 key until a beep sounds.
The LED indicator lights orange.
When the Side 1 key is released, the transceiver will announce
the VOX Gain level.
4 Press the Side 1 key to set the VOX Gain level, from 1 (least
sensitive) to 10 (most sensitive).
Press the Side 2 key to enable or disable the VOX function for the
current channel (you can change this setting for each channel by
selecting a channel with the Channel selector). When turned ON,
a beep sounds. When turned OFF, a double beep sounds.
5 Press the PTT switch to save the setting.
A beep will sound.
The transceiver announces the new VOX Gain level.
6 Turn the transceiver power OFF and then ON again to
activate VOX.
Note:
If key lock or key lock with status memory is ON, you will be unable
to enter VOX setup mode.
If a headset is connected to the transceiver while the VOX function is
switched ON and the VOX Gain level is confi gured to a higher, more
sensitive level, louder received signals may cause the transceiver to
start transmitting.
If no operation is performed for 20 seconds, the transceiver will exit
VOX setup mode.
14
Tabla de contenido
loading

Este manual también es adecuado para:

Nexedge nx-340Nexedge nx-240vNexedge nx-340u

Tabla de contenido