Kenwood NEXEDGE NX-240 Manual De Instrucciones página 15

5 When charging is completed, the indicator lights green.
Remove the battery pack or the transceiver from the
charging slot of the charger.
• It takes approximately 3 hours to charge the battery pack.
• When the charger will not be used for a long time, unplug the
AC adapter from the AC outlet.
Note:
◆
When the indicator blinks red, the battery pack is either defective or
the battery pack contacts are not properly mated with those of the
charger.
◆
When the indicator fl ashes green and orange, the battery pack has
not satisfi ed the charging start temperature. Remove the battery
pack from the charger and wait until it reaches a normal temperature
before charging it again.
◆
The ambient temperature should be between 41°F and 104°F (5°C
and 40°C) while charging is in progress. Charging outside this range
may not fully charge the battery.
◆
The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
Install the cap over the speaker/ microphone jacks when not
using an optional speaker/ microphone.
Note: To keep the transceiver water resistant, you must cover the
speaker/ microphone jacks with the supplied cap.
1
2
Place the cap over the jacks so that the locking tabs
insert into the transceiver grooves.
While holding the cap in place, push it towards the
bottom of the transceiver until the tabs on the cap click
into place.
• To remove the cap, hold the top of the cap in place
with your fi nger while inserting a 2 mm or smaller
fl at blade screwdriver under the bottom of the cap.
Slowly slide the screwdriver in until its tip touches
the tab inside the cap, then gently pry the cap
up (handle of screwdriver moving away from the
transceiver) to remove the cap.
5