Axis Q7406 Instrucciones De Instalación página 6

Page 6
Mounting the AXIS Q7406 into the AXIS Q7900 Rack
The AXIS Q7900 can accommodate 14 Axis blade video encoders. The slots for these are numbered
1-14 from left to right, as seen from the front. The I/O connectors for each slot on the rear panel
are also numbered.
1. Remove a front panel cover from the slot in which the video encoder will be mounted. This is
done by unfastening the screw on each side of the cover.
2. Slide the video encoder into place, using the guides as an aid. The dip switch for setting the line
termination should be visible on the bottom edge.
3. Fix the video encoder in place, using the screws from the front panel cover.
Note:
Front panel covers should be used on all empty slots.
See the tables Pin assignments for the I/O Connector of the AXIS Q7900 Rack, on page 15, and Pin
assignments for the RS-485 Connector of the AXIS Q7900 Rack, on page 16 below for pin
assignment information. For more information about the AXIS Q7900 see the installation guide for
the AXIS Q7900 Rack.
AXIS Q7406 Installation Guide
Screws