Adjusting Cutter Bar Angle; Starting / Stopping The Engine - Stihl FH Manual De Instrucciones

3
Full Harness*
: Put on the full harness (2).
: With the power scythe attached,
adjust length of strap until the spring
hook (3) is at the same height as
your right hip.
* see "Guide to Using this Manual"
FH

Adjusting Cutter Bar Angle

The angle of the cutter bar relative to the
shaft can be adjusted to 8 positions
between 0° (straight) and 90° (right
2
angle).
The additional settings increase the
versatility of the unit.
Adjusting cutter bar angle
: Shut off the engine.
: Pull back the sliding sleeve (1) and
use lever (2) to adjust joint by one or
several holes.
: Release the sliding sleeve and
allow pin to engage the quadrant
(3).
Sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
Starting / Stopping
the Engine
2
3
1
Starting the Engine
Always follow the starting procedure
outlined in the instruction manual of
basic power tool or CombiEngine you
are using.
: Place the unit on the ground: It must
rest securely on the engine support
and the gearbox.
: On units with an adjustable cutter
bar and defined transport positon:
Set the cutter bar to the straight (0°)
position.
English / USA
13