Ice Maker; Ice And Water Dispenser - Gaggenau RF 411 Manual De Uso Y Cuidado

Ice Maker

The Ice Maker makes ice cubes.
The Ice Maker starts to make ice cubes as soon as
the appliance has reached the set temperature. When
the Ice Cube Container is full, the Ice Maker stops ice
production automatically.
,
CAUTION:
Do not place bottles or food in the Ice Cube
Container in order to cool them quickly. The Ice Maker
may be blocked and could be damaged.
Switching On
Note:
If the Ice Maker is used for the first time and/or after
a long period of not being used, do not use the ice
that is produced in the first day for hygienic reasons.
Throw the ice cubes away and clean the Ice Cube
Container.
1. Make sure that Ice Cube Container is in its place
and locked into position.
Press the ICE button Ü.
2.
The symbol "ICE" is lit on the Display Panel.
Switching Off
Note:
Before switching the Ice Maker Off, it is most
important that you switch the Water Supply to
the appliance Off for a few hours.
Press the ICE button Ü.

Ice and Water Dispenser

(not all models)
The following can be dispensed as required:
▯
cooled water,
▯
crushed ice,
▯
ice cubes.
,
WARNING:
Never reach into the Ice Cube Dispenser opening!
Risk of injury!
,
CAUTION:
Do not place bottles or food in the Ice Cube
Container in order to cool them quickly. The Ice Maker
may be blocked and could be damaged.
Using the Ice and Water Dispenser
The Ice and Water Dispenser only works when
the appliance is connected to the water line.
When the appliance has been switched On, it takes
approximately 24 hours until the first batch of ice
cubes are ready.
Once the appliance has been connected, the water
line has to be purged of any trapped air.
Run the drinking water and pour out until the water
can be dispensed without bubbles. Pour away the first
5 glasses.
When using the Ice Maker for the first time, do not
use the first 30-40 ice cubes out of hygienic reasons.
Operating the Ice Maker
When the Freezer Compartment has reached its
freezing temperature, water flows into the Ice Maker
and freezes into ice cubes. When the ice cubes are
ready, they are automatically discharged into the Ice
Cube Container.
Occasionally the sides of the ice cubes stick together.
When they are conveyed to the outlet opening, they
usually break away from each other.
When the Ice Cube Container is full, the Ice Maker
stops ice production automatically.
Note:
To prevent ice cubes from sticking together,
a Rotating Metal Screw (Agitation Function) can be
switched On for 2 seconds (see chapter "Getting to
Know Your Appliance", section "Ice and Water
Dispenser Controls").
15