Ice Maker - Gaggenau RF411704 Instrucciones De Uso

Ice maker

The ice maker is not functioning.
Ice cube production is switched off.
Freezer compartment is too warm.
Ice cube container is not properly inserted.
Ice maker without power.
No water supply.
Low water pressure.
Kink in water hose.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there
will be too few in the ice cube container.
Ice cube production stops even though the ice cube
container is still not full.
Low water pressure.
The water filter is blocked or needs to be replaced.
Freezer compartment is too warm.
Water is leaking out of the appliance.
Water connection is not tight.
--------
Switch on ice cube production.
Set the temperature lower.
~ "Operating the appliance" on page 14
Insert ice cube container fully.
Call customer service.
~ "Customer service" on page 30
Check water connection and contact technician if nec-
essary.
Only connect appliance to pipes with sufficient water
pressure.
Turn off water supply, straighten out kink. Replace
water hose, if necessary.
It takes around 24 hours for an empty ice cube con-
tainer to fill up.
Do not store the ice shovel on the ice in the ice cube
container. Otherwise, the sensor will not detect the
actual fill level of the container.
Only connect appliance to pipes with sufficient water
pressure.
Replace water filter.
Set the temperature lower.
~ "Operating the appliance" on page 14
Check if the connections are fastened firmly and the
water hose is undamaged.
If the water hose is damaged, contact customer service
and have it replaced. Replacement must be performed
by customer service or a similarly qualified person
only.Use original parts supplied by the manufacturer
only.
en-us
Faults – what to do?
29