Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between five different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown below.
Follow these instructionsto changespray tips:
1.
Pull back collar on quick-connect and pull current spray
tip off. Store spray tips in holder provided on the
accessory tray.
A, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER exchange spraytips withoutthetriggerlockedon the
spraygun.
• DONOT twist spraytips whilespraying.
2.
Select desired spray tip:
*
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
,
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select green 25°
or yellow 15° spray tip.
*
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
,
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3.
Pull back on collar, insert new spray tip and releasecollar.
Tug on spray tip to make sure it is securelyin place.
Usage Tips
*
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
,
If you get spray tip too close, especiallyusing a high
pressure spray tip, you may damagesurface being cleaned.
,
DONOT get closer than 6 inches (15 cm) when cleaning
tires.
Cleaningand Applying Detergent
A, WARNING ChemicalBurn Hazard.
.,- ..... Chemicals could cause bodily injury, property
_
damage or death.
• DONOT usecausticliquidwith pressure washer.
• UseONLYpressure washersafedetergents/soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1.
Review use of spray tips.
2.
Prepare detergent solution as required by job.
3.
Place small filter end of detergent siphoning tube into
detergent container.
NOT/CE
Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
NOT/CE Make sure the filter is fully submerged in detergent
while applying detergent.
4.
Make sure black spray tip is installed.
NOTICE Detergent cannot be applied with the high pressure
spray tips (White, Green,Yellow or Red).
5.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
LOWPressure
\
Useto
apply
detergent
Black
White 40°
2600 PSi
2.8 GPM
High Pressure
'L V
'
'
Green25°
Yellow 15°
2800 PSi
2800 PSi
2.7 GPM
2.7 GPM
Red 0°
3100 PSi
2.5 GPM
14
Tabla de contenido
