Worx Jawsaw WG307 Manual De Instrucciones página 18

direction of the teeth (see Fig. H). The
cutting direction is inward on the lower
cutting edge.
9. With the mounting plate (a) toward the
motor and holding the chain in place on
the bar, feed bar and chain into the jaw,
angling over the bar locating pins (d) and
engaging the chain on the drive sprocket
(16) (See Fig I). There is little excess chain
length, therefore, the chain must be
properly fitted in the bar slot to provide
enough extra chain to be pulled over the
drive sprocket.
10. Check if all parts are seated properly (See
Fig J).
11. Refit and tighten the chain tensioner bolt.
Note the cam (e) of the tensioner will
engage the projecting tab (f) of the bar
mounting plate and push the bar outward
to tension the chain, check for correct
tension (See AdJuSTiNG ThE chAiN
TENSioN).
12. Close the access cover and remove the
lock pin.
LUBRICATIOn
18 18
iMPorTANT: The JawSaw is shipped
with an empty oil tank. it is essential to
fill with chain oil before use.
Never operate the JawSaw without
chain oil or an empty tank as this will
result in poor cutting performance,
motor overload and possible burn-out.
FiLLiNG oiL TANk:
uNPLuG ThE TooL bEForE FiLLiNG
wiTh oiL.
1. Fill oil bottle with bar oil. (See Fig. K)
2. Rest the JawSaw with the oil filler (6) facing
upward
3. Lift the rubber oil filler flap (g) open.
4. Use bottle to fill oil reservoir. (See Fig. L)
5. Close the filler flap by pressing the plug
part of the flap into the oil filler to seal. (See
Fig. M)
iMPorTANT: Use only the
recommended oil to avoid damage
to the JawSaw. Never use recycled/old oil.
Use of non approved oil will invalidate the
Guarded electric chain saw
warranty.
chEckiNG ThE AuToMATic oiLEr
The JawSaw uses a much lower chain speed
than a conventional chainsaw so it needs
much less oil.
However is it very important that it always has
oil.
Check the oil tank window and refill as
necessary.
During operation, periodically check the
chain and bar. A slight oil presence should be
visible. If the chain and bar appear completely
dry, then remove the bar and chain (see
previous section) to ensure the bar oil hole is
not blocked.
If the oil hole is clear, there is oil in the tank
and still no oiling of the chain is visible –
contact Worx customer service (contact 1-866-
354-9679).
OPeRATIOn
PrEPArE your JAwSAw For uSE
wArNiNG: read and understand
all instructions. Failure to follow all
instructions listed may result in electric
shock, fire and/or serious personal injury.
wArNiNG: Sharp moving blade.
To prevent accidental operation,
ensure that the tool is disconnected from
the power source before performing the
following operations, failure to do this
could result in serious personal injury.
cAuTioN: Sharp moving blade.
Always wear protective gloves
when installing or removing the chain,
the chain is sharp and can cut you when
it is not running.
ATTAchiNG ExTENSioN cord
1. To prevent disconnection of appliance
cord, secure extension cord to extension
cord retainer.
2. An extension cord retainer is supplied to
reduce strain on the power cord. To use
this feature, form a loop at the end of the
extension cable and bring this through the
opening at the cable hook and suspend in
the tension relief at the hook. (See Fig N)
en