Operating The Printer; Controls - Weidmuller THM Basic 300 Instrucciones Para El Manejo

4.

Operating the Printer

4.1

Controls

4.1.1 Mains power switch
The mains power switch is located on the left side of
the printer.
Position 0: Off
Position I: On
DIP switches
We recommend that you run the THM
Basic 300 printer with its factory default
settings! (All DIP switches set to OFF.)
Turn off the printer before changing the
DIP switches.
DIP switch Function
1 ON:
OFF: thermal transfer print
2 ON:
OFF: turns label withdrawal mode off
3 reserved
4 reserved
5 ON:
OFF: Light sensor deactivated
6 reserved
7, 8 8 | 7
0 | 0 – 9600,n,8,1
0 | 1 – 19200,n,8,1
1 | 0 – 38400,n,8,1
1 | 1 – 57600,n,8,1
Table 1 DIP switches
1168670000/02/08.11
direct thermal print
allows label withdrawal (tear-off mode)
Light sensor activated
Figure 6 DIP switches
After the setting of the DIP-switch 5 per-
form a printer calibration.
Comment
Print settings
Preset: OFF
Label withdrawal (tear-off mode)
Preset: OFF
always OFF
always OFF
Comment: Change from reflex to
light sensor
Preset: OFF
always OFF
RS232 serial interface
Baud rate setting:
0: OFF, 1: ON
Preset: 00
Operating the Printer
45