Tabla de contenido
98
ii-1
ii-2
Installation Instructions
ii Transportation, unpacking and contents
Transportation
The wheel balancer is supplied on a pallet.
• Use a pallet truck (Figure ii-1) to bring the wheel
balancer to its working area.
Unpacking
PREVENT THE STRAPS FROM SPRINGING
LOOSE AFTER BEING
• Cut the straps.
• Open the top of the box.
• Remove staples at the bottom of the box. Lift the
box up and over the unit.
• Carefully unwrap the balancer and spare parts
supplied.
• Check the contents of the shipment.
Contents
The shipment contains:
-
a wheel balancer.
-
Documentation with Declaration of Conformity (CE).
-
the accessories mentioned in Section 3.1 of the
Operator's Manual.
-
3 storage hooks and fl anges.
-
a mains power cable.
-
a wheel guard assembly (if present).
Tools required
-
Screwdriver / bar (diameter 5 mm Max)
-
Pin / bar (diameter 10 mm Max)
-
Wrench
13
mm
-
Wrench 17 mm
Positioning
Remove the bolts that secure the wheel balancer
•
on the pallet.
DO NOT LIFT OR MOVE THE WHEEL
BALANCER BY THE MAIN SHAFT OR
MEASURING
UNIT.
Refer to Figure ii-2. Move the wheel balancer from
•
the pallet to its working location.
Note: Use the storage hooks (mount as
instructed in Chapter iii) and/or the wheel guard shaft
(if present) to handle the wheel balancer.
CUT.
Tabla de contenido
