Tabla de contenido
70
5-29
5-30
5-31
Operation "MODE"
Code C4
Figure 5-29 Eventual residual clamping device imbal-
ance compensation.
High precision measuring (This operating mode cannot
be stored in the permanent memory).
Once compensation has been performed, if the clamp-
ing device is changed, this value must be deleted or
recalculated using the new device.
To delete clamping device compensation , set the
operating state to 0.
Compensation should be deleted when the machine
is calibrated or recalibrated, if imbalance optimisation
(silencing) is performed or if the machine is turned OFF.
0
= Perform compensation
1
= Compensation performed
0
= Disable compensation after the measuring run.
Code C5
Figure 5-30 Braking of the wheel when the wheel guard
is opened during the measuring run
0 =
No braking
The wheel rotates when the wheel guard is open.
Make sure that the wheel is not blocked by a tool or
similar item.
Wear safety goggles and tightly fi tting working clothes.
1* =
Braking
The selected mode of operation can be transferred to
the permanent memory.
Code C6
Figure 5-31 Entering the number of wheel spins per
measuring run. Between 5 and 25 spins are possible,
preset by the manufacturer at 10 spins per run.
Example > change to 15 spins per run.
WARNING: REDUCING THE NUMBER OF SPINS
PER RUN MEANS THAT THE MEASUREMENT WILL
BE LESS PRECISE.
The operating mode selected can be obtained from
the permanent memory.
* = Preset by the manufacturer
Tabla de contenido
