After-Sales Service - Hofmann geodyna 7100 Manual De Operador

Tabla de contenido

6-10

6-11

6-12

6-13

6-14

Trouble shooting

H28 - Figure

6-10

The gauge was moved too slowly.

Return the gauge the starting position and repeat

the operation, bringing the gauge towards the weight

application point again.

H80 - Figure

6-11

Recalibration was not set up. As a result, it cannot be

performed by the operator.

Press the STOP key to clear the message.

Call the service team for machine calibration.

H82 - Figure

6-12

The self-test was disturbed (e.g.: by turning the wheel).

The message is displayed for 3 seconds, then the

measurement is repeated (max. 10 times) or aborted

by pressing the STOP key.

H90 - Figure

6-13

Wheel acceleration was too slow, or braking was too

weak after a measuring run.

If the main shaft does not reach the required speed,

check that the brake is not activated or the weight of

the wheel is too great. In this case:

Release the brake.

Make sure that the shaft with the wheel clamped on it

can rotate freely.

Turn the wheel by hand then press the START key.

If the error cannot be eliminated, call the service team.

H91 - Figure

6-14

Speed variations during measuring run. The brake

may be ON.

Release the brake.

Make sure that the shaft with the wheel clamped on it

can rotate freely.

Repeat the run.

7.2