Ecler DP 300 Manual De Instrucciones página 26

5. Delay
The delay of each output can be adjusted between 0 and 635ms in 0,021ms steps.
OUT 1
Delay
The delay units shown on the right of the display (milliseconds in this case) depend on the "Delay
measurement units adjustment" in the SETUP menu.
These units should be chosen to best suit the applications.
To adjust the Delay amount, use the encoder wheel or the ◄ and ► keys.
6. Delay Link
The Delay Link can be used to keep the same delay offset between channels that have the same delay
amount.
If, e.g. you configure a certain amount of delay to a channel that is stereo linked, the pair channel will
automatically have the same delay assigned.
OUT 1
Delay Link
Depending on the operating mode, only certain preset delay links can be assigned, as following table
shows:
Mono Mode
Output OUT1 with OUT2
Output OUT2 with OUT3
Output OUT3 with OUT4
Output OUT4 with OUT5
Output OUT5 with None (Off)
2 channel 3 way mode
Output OUT1 with OUT3
Output OUT2 with OUT4
Output OUT3 with OUT5
Output OUT4 with OUT6
Output OUT5 with None (Off)
Output OUT6 with None (Off)
3 channel 2 way mode (LCR)
Output OUT1 with OUT4
Output OUT2 with OUT5
Output OUT3 with OUT6
Output OUT4 with None (Off)
Output OUT5 with None (Off)
Output OUT6 with None (Off)
To change the Delay link setting, use the encoder wheel or the ◄ and ► keys.
26
Band 1
0.000ms
Band 1
Off