Control Leds; Button; Wifi Connection (Wps); Restore Factory Settings (Reset) - Miele XKM 3100 WCDS Instrucciones De Manejo

en - Guide to the appliance
WiFi connection
(WPS)
Restore factory
settings
(Reset)

Firmware update

36

Control LEDs

The control LEDs (light emitting diodes) give status information about
the communication module.
LED
LIT UP GREEN
LIT UP YELLOW
FLASHES GREEN A WiFi connection is being established via
FLASHES YEL-
LOW
FLASHES
alternately
GREEN and RED
FLASHES RED

Button

The button on the module has the following functions:
WPS log in is required to connect the module directly to the internet,
e.g. for updating the module Firmware.
Instructions for logging in to WPS can be found in "Firmware update".
The module can be reset to factory default settings by continuously
pressing the button.
Press and hold the reset button for approx. 10-15 seconds until the

LED begins to flash yellow.
Restoring the settings takes approx. 30 seconds. The module will
then carry out an automatic restart and will restart in AP mode. The
restart is completed when the LED on the module lights up steady
green or yellow.
An update of the module Firmware can be initialised from the Miele
app or by pressing the button.
Instructions for this can be found in "Firmware update".
Status
The module is ready for use and a WiFi con-
nection has been established.
The module is ready for use and a WiFi con-
nection can be established.
WPS procedure.
Resetting in progress.
Firmware update in progress.
Communication fault has occurred.
Check the configuration of the RS232 interface
on the washer-disinfector.