Assembly & Adjustments; Operation Instructions - Urrea COMP9100 Manual De Usuario Y Garantía

ASSEMBLY & ADJUSTMENTS
HANDLE
The handle must be fitted in the following
manner:
1. Loosen the screws in each of the handle
fixing tubes using an hexagonal key (not in-
cluded).
2. Insert the two ends of the
handle into the fixing tubes.
3. Tighten the screws to se-
cure the handle in place, us-
ing an hexagonal key (Fig.1).
WHEELS
Fit the wheels as follows:
1. Position the back of the wheel onto the met-
al bracket located on the tank.
2. Then insert the wheel bolt through the
wheel and then through the hole in the brack-
et under the tank.
3. Attach and tighten the nut with washer, on
the inside of the bracket tightening with two
spanners. Repeat for the second wheel.
NOTE: Tires should be inflated not exceeding
30 psi.
RUBBER FEET
1. To fit the two rubber feet
and fit a washer onto the
head of the bolt and pass
the bolt and washer through
the rubber foot as shown in
figure 2.
2. Place the bolt through the
hole in the front bracket and
secure it with the nut and
washer. Tighten the nut with
a spanner, whilst holding the
head of the bolt with your
thumb, do not over tighten.
Repeat for the other rubber foot (Fig.3).
OIL
WARNING: The air compressor must be
filled with oil prior first use. To prevent pos-
sible spillage of oil during transport, the com-
pressor oil is supplied in a separate container. It
must be added to the compressor before turn-
ing the compressor on. Failure to add the oil
will cause non repairable damage to the com-
pressor and will void the warranty.
1. Remove the plastic oil fill-
ing cap (Fig.4) located on the
top of the crank case of the
compressor housing.
2. Use the oil supplied to fill
the crank case until the oil
level as seen in the oil level
Fig.1
glass is up to the mid point
of the red circle (Fig.5).
3. Replace the oil filling cap.
Make sure the cap is fully fit-
ted and firmly in position.
PRE-START ROUTINE
1. Ensure that the location
for the compressor is clean,
dry and well ventilated.
2. Ensure the crank case has
been filled with oil and is at
the correct level, and the air
filter has been fitted (Fig.7
CLOSED).
3. Open the regulated out-
put valve. Open the valve by
rotating the air tap so it is in
line with the air outlet (refer
Fig.2
to Fig.6 OPEN). To close the
valve, rotate the air tap so it
is facing to the right or the
left side of the air valve (re-
fer to the CLOSED picture).
4. Start the compressor by following the pro-
cedure in the section "To start and stop the
compressor".
For the first time of operation, run the com-
pressor for 10 minutes with no load and with
the outlet valve open to ensure all parts are
well lubricated.
Fig.3
will be discharged from the outlet and care
should be taken that this discharge is not di-
rected towards you the operator, or other per-
sons within the area.
STARTING THE UNIT
ous injury or death may result from fire caused
by gasoline contacting hot surfaces.
E N G L I S H •

OPERATION INSTRUCTIONS

WARNING: Be aware that pressurised air
WARNING: Gasoline is very dangerous. Seri-
U se r's m a nua l
Fig.4
Fig.5
Fig.6
open
Fig.7
closed
13