DeWalt D25960 Manual De Instrucciones página 25

FIG. 3B
E
D
Adjusting the Side Handle (fig. 1)
WARNING: Always operate the machine with the side handle
properly mounted.
The side handle (F) is assembled on the machine to suit both RH- and
LH-users
1. Loosen the clamp knob (C) and rotate the side handle to the
desired position.
3. Lock the side handle in place by tightening the clamp knob (D).
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: Be aware of the location of pipework and wiring.
WARNING: Apply a pressure of approx. 44–66 lbs. (20–30 kg.) to
the tool. Excessive force does not speed up chiselling but decreases
tool performance and may shorten tool life.
D
23
Proper Hand Position (fig. 4)
FIG. 4
WARNING: To reduce the
risk of serious personal injury,
ALWAYS use proper hand
position as shown.
WARNING:
To
reduce
the risk of serious personal
injury, ALWAYS hold securely
in anticipation of a sudden
reaction.
Proper hand position requires
one hand on the side handle (F),
with the other hand on the main
handle (B).
Switching On and
Off (Fig. 1)
To turn the tool on, set the on/
off switch (A) to position 1. To
turn the tool off, set the on/off
switch (A) to position 0.
Demolition,
Chasing and Channelling
(Fig. 1, 4)
WARNING: Ensure that the cutting edge does not show
discoloration caused by too much pressure. This may impair the
hardness of the accessory.
Various types of chisels are available as an option.
1. Select the appropriate chisel. Clean and grease its shank.
2. Insert the chisel and check whether it is properly locked.
3. Fit and adjust the side handle (F) and make sure it is firmly
tightened.
B
F