Tabla de contenido
Idiomas disponibles
Idiomas disponibles
-
In order to maximise the performance of the appliance, make sure that it is free of any obstruction
EN
that could block the airflow.
-
If the appliance is not used for an extended period of time, unplug the appliance.
4.3 Wait 3 minutes before resuming operation
After turning off the appliance, the operation cannot be restarted in the first 3 minutes to avoid
damaging the compressor
4.4 Full tank indication and auto shut off
The
LED lights up when the tank is full (See "CLEANING AND MAINTENANCE"), or when the
tank is removed or not replaced in the proper position. In this case, the appliance automatically
shuts off.
4.5 Auto defrost
When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue
to run until the frost disappears. While auto defrosting, the
Note:
-
During defrosting operation, it is normal that the appliance may make noise of refrigerant flowing.
4.6 Auto re-start
If the appliance breaks off unexpectedly due to power cut, it will restart with the previous function
setting automatically when the power resumes.
Caution:
-
The appliance may not work when the required humidity is higher than the ambient humidity.
-
The operating temperature range of the appliance is 5-32°C.
-
When the appliance is on, it is normal for the compressor to heat up and increase the ambient
temperature.
5. CLEANING AND MAINTENANCE
Warning:
-
Always unplug the appliance before cleaning.
5.1 Instruction for emptying
Condensation water can be stored in the tank or drained continuously by a PVC tube (not supplied).
5.1.1 Using the tank
When the appliance is operating, condensation water can be drained to the tank. The appliance
stops working when the tank is full, and the
both sides of the tank and pull it out (Fig.2), then empty the tank, finally replace the tank.
Fig.1
LED lights up.
LED lights up. Pull out the tank a bit (Fig.1), then hold
Fig.2
21
Tabla de contenido
