Electrical Connections - V2 VULCAN 24V Instrucciones De Uso

ELECTRICAL CONNECTIONS

VULCAN-230V / VULCAN-120V
Motor cable
DX motor
YELLOW - GREEN GND
BLUE COMMON
BLACK OPENING
BROWN CLOSING
WARNING: Always connect the earth cable to the
mains power earth system. Use the special fastom shown
in the figure, and a cable with a minimum cross sectional
area of 2.5 mm 2
VULCAN-24V
Motor cable
DX motor
+
BLU
-
MARRONE
ENCODER connection
To connect the encoders please refer to the control unit manual.
WARNING: For the encoders to work properly it is
essential that the stoppers inside the case are installed
correctly.
ATTENTION: DO NOT use the motor cable channel for
the sensor cables.
ATTENTION: extensions of the cables must be made
only with a 4x0,22 shielded cable with polyethylene sheath
ATTENTION: connect the shielding braith sheath to the
common accessories. Check that the ground of the power
supply of the accessories is connected to the common
accessories.
CONTROL UNIT
SX motor
GND
COMMON
CLOSING
OPENING
CONTROL UNIT
SX motor
-
+
11