Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Overheat protection
When the tool or battery is overheated, the tool stops
automatically without any indications. The tool does not
start even if turning on the tool. In this situation, let the
tool or battery cool before turning the tool on again.
NOTE: The battery overheat protection works only
with a battery cartridge with a star marking. The tool
overheat protection system works with any battery
cartridges.
1
► 1. Star marking
Overdischarge protection
► 1. Battery indicator
When the remaining battery capacity gets low, the
battery indicator blinks on the applicable battery side.
By further use, the tool stops and the battery indicator
lights up about 10 seconds. In this situation, charge the
battery cartridge.
1
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Power switch action
WARNING:
•
Before installing the battery cartridge in the
tool, always check to see that the switch
lever actuates properly and returns to the
original position when released. Operating a
tool with a switch that does not actuate properly
can lead to loss of control and serious personal
injury.
6 ENGLISH
1
Off
Blinking
malfunctioned.
2
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
Tabla de contenido
