Attaching The Anti-Kickback Device - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 14
FIG. 8
10. Lower the front of the guard assembly until
the metal "fork" is parallel with the table
(Fig. 8).
11. Press down on the guard release lever until
you feel and hear it snap into the locking po-
sition. Check that the guard assembly is se-
curely connected (Fig. 8).

ATTACHING THE ANTI-KICKBACK DEVICE

12. Attach the Anti-Kickback Device into the flat
recessed area of the riving knife (Fig. 9).
13. Squeeze the compression pads while nesting
the device into the flat area (Fig. 9).
14. Release the compression pads such that the
Anti-Kickback Device locks onto the riving
Guard Assembly
Anti-Kickback Device
FIG. 9
knife immediately behind the guard assembly.
Check that the attachment pin is securely con-
nected into locking hole. Carefully raise and
lower the pawls – when letting go, the spring-
loaded pawls must come down and contact
the table insert (Fig. 9).
Hint: Position the Anti-Kickback Device behind the
flat recessed area and slide it towards the front until
it drops into the recessed area – then release the
compression pins.
Note: The two attachments are independant of
each other, so the Anti-Kickback Device can be at-
tached before the Guard Assembly.
Pin Hole
-14-
Guard Release Lever
Squeeze
Pawls
Riving Knife