Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Monogram embrodiery
1.
Sew and fill in the monogram along the script using a slow
and smooth movement of the frame.
2.
Secure the monogram by sewing a few straight stitches at the
end of the last letter, remove the material from the machine in the
usual manner.
Motive embroidery
1.
First sew the outline of the motive, moving the embroidery frame
accordingly.
2.
Fill in the motive from the contour to the inside then back to the
outside, until the contour has been completely filled in or embroide-
red. Place the stitches very closely together.
Notice
A long stitch is created by moving the frame more quickly,
a shorter stitch by moving the frame more slowly.
3.
When you have finished, secure the work by sewing a few straight
stitches.
Changing the lamp bulb
Important
Remove the power plug
k
from the wall socket! Danger of electric shock.
1.
Loosen the screw of the front cover
illustrated.
2.
Remove the front cover
h
from the machine.
3.
Exchange the bulb of the sewing machine lighting.
4.
Replace the front cover
h
and tighten the retaining screw.
Lubricating the machine
Important
Remove the power plug
k
from the wall socket! Danger of electric shock.
1.
Loosen the screw from the front cover
h
using the screwdriver
Y
as
h
and remove the front cover
h
2.
Apply 2 to 3 drops of sewing machine oil
in the diagram.
3.
Replace the front cover
socket.
4.
After lubrication, start the machine up in rapid operation, without the
needles being threaded, for a short period to distribute the oil.
5.
Remove the power plug
cover
h
.
6.
Wipe off any superfluous oil.
7.
Replace the front cover
Notice
The machine should be lubricated once a week if it is being used
for more than one hour a day. Lubricate the machine daily when
it is used more frequently.
Cleaning
Dismantling of the gripper
1.
Bring the needle into the highest possible position or, preferentially,
dismantle the needle.
2.
Open the flap on the sewing table.
3.
Remove the bobbin case by the opening its flap and then pulling
the bobbin case carrier from the bobbin case carrier pin.
4.
Press the two catches
i
.
direction and then remove the released retainer
- 51 -
K
to all points indicated
h
and insert the power plug
k
k
from the wall socket and remove the front
h
and tighten the screw.
from the rear retainer
u
in an outward
u
.
into the wall
Hide quick links:
Capítulos
Tabla de contenido
