Assembly On Untc-Ev - Utnc-I - RHOSS KCMS/PCM Instrucciones De Uso

Use the wall-mounted control panel to detect the room temperature
(KPCM accessor y), by setting the Probe In function (see paragraph
I.2.1.7). In this cas e, the cable of probe ST1 c an be wound and left
inside the board c ontainer.
If the control panel is positioned in an area where the correct room
temperature c annot be read, probe ST 1 must be mounted in a position
in which the bul b is in c ontact with the air in the room; the Probe Out
functi on mus t be set on the c ontr ol panel (see paragraph I.2.1.7). Mount
the probe (ref. 3 in the figure below) usi ng the self-adhesive base (ref. 2
in the figure below) and the clamp (ref. 1 i n the figure bel ow) s upplied
with the kit.
ST1
Probe ST2 must be passed through the hole with the cable gland on the
unit and it must then be fastened to an elbow of the exc hanger with the
clip supplied in the kit (ref. 1 i n the figure bel ow).
1
II.3.5

ASSEMBLY ON UNTC-EV - UTNC-I

Make 4 hol es on the unit, in line with the indications provided i n the
figure below, to mount the board container on the UNTC-EV and UTNC-
I unit.
=
1
2
3
ST2
210 =
Remove the c over of the board c ontainer and sec ure it to the unit using
the screws s upplied with the kit as s hown in the figure bel ow.
Use the wall-mounted control panel to detect the room temperature
(KPCM - KICM accessor y), by setting the Probe In function (see par a.
I.2.1.7). In this cas e, the cable of probe ST1 c an be wound and left
inside the board c ontainer.
If the control panel is positioned in an area where the correct room
temperature c annot be read, probe ST 1 must be mounted in a position
in which the bul b is in c ontact with the air in the room; the Probe Out
functi on mus t be set on the c ontr ol panel (see paragraph I.2.1.7). Mount
the probe (ref. 3 in the figure below) usi ng the self-adhesive base (ref. 2
in the figure below) and the clamp (ref. 1 i n the figure bel ow) s upplied
with the kit.
ST1
Probe ST2 must be mounted on the water inlet pipe of the unit with the
relative clamp supplied with the kit (see the figure below). Is olate the
pipes with anti-condensati on tape after having mounted probe ST 2.
38
SECTION II: INST ALL ATION
1
2
3
ST2