Assembling The Kit; Assembly On Brio-Ev - Brio-I - RHOSS KCMS/PCM Instrucciones De Uso

The rec essed panel c an be installed i n recess ed boxes and 3-module
plates , as s hown in the following figures:
VIMAR Idea; Idea Rondò; Plana
VIMAR
BTicino Living Inter national; Light; Light Tec h; Matrix
BTicino
II.3

ASSEMBLING THE KIT

DANGER !
Pay utmost attention to the sharp edges of the
board container and heat exchang e coil when
assembling the kit as they can cause cuts if used
incorrectly. U se suitable per sonal protective
equipment (gloves, goggles, etc).
II.3.1 ASSEMBLY ON BRIO-EV – BRIO-I
Open the doors and us e a screwdri ver to remove the screws with which
the c abinet is s ecured to the body of the unit.
Open the c over of the board contai ner (ref. 1 in the figure below).
Secure it to the opposite side of the water connecti ons using the screws
supplied with the kit (see the figure bel ow). F asten the s upport of the
control panel (not pr esent in the KCMS and KCMI Kits, ref. 2 in the
figure below) to the upper end of the bac k panel using the screws
supplied with the kit (see the figure bel ow).
Attac h the adhesi ve l abel (ref. 6 in the previous figure) to the bac k panel
of the unit i n line with the fastening holes of the ter minal board. Then
fasten the termi nal board (ref. 3 in the previous figure) usi ng the screws
supplied with the kit. Attac h c onnectors 4 and 5 (s ee the previous
figure) and c onnect the earth to the screw on the bac k panel (see the
figure below) and then cl ose the cover of the board c ontainer.
35
SECTION II: INST ALL ATION
2
1
6
ST1
3
4
5
KCMI
1
6
ST1
3
ST2