Assembly On Utna; Assembly On Utnb - Yardy Hp - RHOSS KCMS/PCM Instrucciones De Uso

Probe ST1 must be s et in positi on with the s pring pressing on it (see the
figure below).
Yard yEV – Yard y-I – Yard y ID
version MOP – MOT – IVP – IVF – IOP
Use the wall-mounted control panel to detect the room temperature
(KPCM accessor y), by setting the Probe In function (see paragraph
I.2.1.7). In this cas e, the cable of probe ST1 c an be wound and left
inside the board c ontainer. If the control panel is positi oned in an area
where the c orrect room temperatur e cannot be read, probe ST1 mus t
be mounted i n a positi on i n which the bulb is in contact with the air in
the room; set the Probe Out functi on on the control panel (see
paragraph I.2.1.7).
Probe ST2 must be passed through one of the holes on the bac k panel
of the unit. It mus t then be fas tened to an elbow of the exc hanger with
the clip supplied in the kit (ref. 1 in the figure below).
1
II.3.3

ASSEMBLY ON UTNA

Open the electrical panel compartment of the SV ventilating sec tion.
Remove the c over of the board c ontainer (ref. 1 i n the figure below) and
secure it i nside the el ectrical panel compartment of the unit using the
screws s upplied with the kit.
Use the wall-mounted control panel to detect the room temperature
(KPCM accessor y), by setting the Probe In function (see paragraph
I.2.1.7). In this cas e, the cable of probe ST1 c an be wound and left
inside the board c ontainer.
If the control panel is positioned in an area where the correct room
temperature c annot be read, probe ST 1 must be mounted in a position
in which the bul b is in c ontact with the air in the room; set the Probe Out
functi on on the control panel (see par a. I.2.1.7).
ST1
ST2
1
ST1
ST2
Mount the probe (ref. 3 in the figure below) using the s elf-adhesi ve bas e
(ref. 2 in the figure below) and the clamp (ref. 1 in the figure bel ow)
supplied with the kit.
ST1
Probe ST2 must be passed through the rubber gas ket of the water inlet
pipe of the exchanger (see the figure bel ow).
It must then be fastened to an elbow of the exchanger with the clip
supplied in the kit (ref. 1 in the figure below).
1
II.3.4

ASSEMBLY ON UTNB - YARDY HP

Remove the c over of the board c ontainer and sec ure it to the unit using
the screws s upplied with the kit (ref. 1 in the figure below).
1
37
SECTION II: INST ALL ATION
1
2
3
ST2
ST2
UTNB
ST1
ST2
YARDY HP
ST1
ST2