Maintenance And Storage; Main Components - TRAPP HT-500 Manual De Instrucciones

Instructions to Assemble the Protection Device
Before switching on and using the hedge trimmer,
install the protection device as described below:
Place the protection device (1) in the front part
 
of the equipment.
Fix it by using the two screws (2) supplied as
  shown in the picture.
Warning!
Never use the hedge trimmer without the
protection device.
Warning!
Any and every maintenance or cleaning shall
be carried out with the equipment switched
off and unplugged.
Tighten all nuts and screws to make sure the
 
hedge trimmer is in usage conditions.
For safety reasons, substitute the parts that are
 
damaged or have worn out.
Check and control the status of the power
 
supply cord; never mend the cord with
insulation tape.
Body
Handle
Fig. 1
24

Maintenance and Storage

Main Components

4
Carefully remove debris buildup at air inlets
 
and cutting blades.
Never use a water jet to clean the hedge
  trimmer; clean it with a sponge or cloth
soaked in neutral detergent.
For easier operation and longer life, lubricate
 
the blades before each use.
Make sure the blade protector is in place
 
before transportation or storage.
If blades wear out or get damaged, take
 
your hedge trimmer to the nearest TRAPP
technical assistance shop for maintenance.
Safety lever
3
Protection device
www.trapp.com.br
2
1
2
Blades