Remote Control; Software Settings, Remote Control; Pair The Remote Control With The Power Unit - Husqvarna PP220 Manual De Instrucciones

Remote control

General
When the power unit is used together with WS220, a
remote control should be connected to the power unit to
control the wall saw. The remote control is included with
purchases of the wall saw equipment and is kept in a
storage box together with associated accessories.
The wall saw is controlled wirelessly with the remote
control via radio communication between the remote
control and the power unit, or alternatively via the CAN
cable between the remote control and the power unit.
The first time the remote control is to be used together
with the power unit, the remote control has to be paired
with the power unit in order for the radio communication to
work. This may already have been done if the power unit
was purchased together with the wall saw equipment. If
pairing has not been performed, the remote control will
not be able to connect to the power unit via radio
communication and the display will show that it is looking
for units and will try to connect, however without success.
First check, however, that the power unit is active with the
power cable connected and that the emergency stop has
not been pressed down, when carrying out a check to see
if pairing has been performed.
Follow the instructions under Software settings, remote
control below for instructions on how to pair the remote
control with the power unit.

Software settings, remote control

Pair the remote control with the power
unit
For radio communication between the remote control and
the power unit to work, the relevant remote control must
be paired with the relevant power unit.
This is a safety measure to guarantee that the power unit
can only be controlled by one remote control. Radio
communication does not work until this measure has
been carried out.
If the accompanying remote control is exchanged or if it is
necessary to swap remote controls between two units, the
remote control must be rematched with the unit.
• Connect the remote control using the supplied CAN-
cable. Tighten the cable connector screws by hand.
• Allow the remote control to fully charge and await the
home screen.
MENU SYSTEM
• Press the "OK" button to access the menu.
• Go to "SETTINGS". Browse with the arrow keys and
confirm with "OK".
>MENU
• Go to "PAIR RADIO". Browse with the arrow keys and
confirm with "OK".
>>SETTINGS
A message is displayed on the screen to indicate if the
pairing was successful or not. Try again if the pairing fails.
Read through the operator's manual for the wall saw for
instructions on how to control the saw with the remote
control.
When the remote control is active the display on the
power unit switches off.
NOTICE! The remote control for the PP220 is also
compatible with the PP480 HF and the PP440 HF units.
The remote control menu system therefore has sub-
menus that are not appropriate for the PP220.
OK
ON/OFF
0
20 DEC
DRIVE CHOICES
SETTINGS
SERVICE
20 DEC
TIME & DATE
[20:51 2010-01-12]
LANGUAGE
[ENGLISH]
SET UNITS
[METRIC]
PAIR RADIO
20:55
20:55
–
English 15