Erasing Or Unfinalizing A Cd-Rw - Teac LPR550USB Manual Del Usuario

Erase procedures are possible only on an unfinalized CD-RW disc .
If a CD-RW disc has been finalized, unfinalize it prior to erasure .
Note that it is not possible to perform any erase or unfinalize
procedures on a CD-R disc .
It is possible to erase the last recorded track . It is also possible to
erase a whole disc .
1 Press the CD button to select "CD".
2
Load a recorded CD-RW.

Erasing or Unfinalizing a CD-RW

3 Press the FINALIZE/ERASE button in the stop mode.
Each time the FINALIZE/ERASE button is pressed, the display
changes as follows:
"UnFInAL" (unfinalize) appears when a finalized disc is loaded .
"FInAL" appears when the disc has not been finalized . If you
press the FINALIZE/ERASE button again, "ErASE" and the last track
number will appear .
UnFInAL
Select this to unfinalize the disc .
ErASE XX (the number of the last track recorded on the
disc)
Select this to erase the last track on the disc .
< This will not appear when only one track is recorded on the disc .
ErASEALL
Select this to erase all the tracks .
< To erase a track in a finalized CD-RW, unfinalize (UnFInAL) first
and then erase the track by the same procedure (ErASE or
ErASEALL) .
< To cancel the erasing or unfinalizing process, press the STOP
button (H) .
4
Press the ENTER button to start finalizing.
The remaining time for the operation appears in the display .
When the operation has been finished, the display returns to the
track/time display .
During erasing/unfinalizing, no buttons will work .
Never turn the power off or unplug the power cord.
< This operation cannot be undone . If you are going to erase one
or all tracks, make sure that they are recordings that you really
want to erase .
29