JVC TK-C9510E Manual De Instrucciones página 22

Connection/Installation
Connection (Continued)
Sync Signal Connection
When composite sync signals or composite video signals are input from
the [SYNC IN] terminal with the [LLlINT/VL] switch set to "INT/VL",
external synchronization (V synchronization) can be performed.
Memo Genlock synchronization cannot be performed for signals with a
significant amount of jitter, such as VTRs and video disc recorders.
For more details, consult your JVC dealer.
Power Supply Connection
When power is supplied to the camera, the [POWER] power indicator
on the side panel lights up.
AC 24 V or DC 12 V (TK-C9510E)
To prevent connection errors or a cable disconnection, use a lug plate
to connect to the terminal. The following table shows the connection
distances when a two-core VVF (vinyl-insulated vinyl sheath cable) is
used. (Reference value)
Conductor diameter (mm)
Max. connection distance (DC 12 V)
Max. connection distance (AC 24 V)
If thin cables are used, the resistance of the cables will be
Memo
high, and a significant voltage drop will occur when the
camera is at its maximum power consumption. Either use a
thick cable with low resistance or place the power supply
near to the camera and shorten the length of the cable to
restrict the voltage drop at the rated current of camera to
below 10 %. If voltage drop occurs during operation, the
operation will become unstable.
Do not connect the AC 24 V cable to a commercial power
supply. If it is connected by mistake, the internal circuit may
be damaged. In this case, stop using the camera and send it
to the nearest JVC dealer for inspection.
Do not connect DC 12 V and AC 24 V cables at the same time.
When using a DC 12 V power supply, check to ensure that
the polarity of the cable is correct.
The AC 24 V power supply must be isolated from the
primary line. (ISOLATED POWER ONLY)
E-22
Φ 1.0
and more and more
50 m
130 m
Φ 1.6 Φ 2.0
and more
140 m 220 m
350 m 550 m