System Connection; Connection Diagram - JVC TK-C9510E Manual De Instrucciones

Connection/Installation

System Connection

Connection Diagram

CAMERA1
MACHINE ID : 1
（MENU Screen）
RX TERM : OFF
(Switch)
CAMERA2
MACHINE ID : 2
（MENU Screen）
RX TERM : OFF
(Switch)
CAMERA8
MACHINE ID : 8
（MENU Screen）
RX TERM : ON
(Switch)
.
During control using RM-P2580, select "JCCP" for the
Memo
[COMMUNICATION] item on the [MAINTENANCE] screen. On
the [COMMUNICATION (JCCP)] screen, set [PROTOCOL 1] to
"MULTIDROP", and [PROTOCOL 2] to "DUPLEX".
For control using a device other than RM-P2580, perform
setting using the switches and menu screen according to the
system in use.
For systems using RM-P2580, multiple cameras (up to 16 units)
are connected using a set of control signal cables. As such, the
entire system will not function properly if the switch setting for
any one of the connected cameras is incorrect. "Control Signal
Cable Connection on Camera (Rear)" (A page 19)
E-18
Power cable
Control signal
cable
TO CAMERA
RX+ RX- TX+ TX-
1 2
ON
Video signal cable
DATA I / O
UNIT CAMERA
COM 1 2 3 4 5 6 7 8 COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO ALARM COM SW COM
VIDEO INPUT
1 2 3 4 5 6 7
3 4 5 6 7 8
1 2 3 4 5 6 7 VIDEO OUTPUT
RM-P2580
SERIAL-1 SERIAL-2
8
MONITOR MONITOR
OUTPUT OUTPUT
1 2
8
Monitor