Options - Sideguard; Options - Hemiplegic Armrest; Options - Anti-Tip Tubes; Options - Lap Belt - Sunrise Medical Breezy RelaX2 Manual De Usuario

options - sideguard

height.adJustable
arnrests
To adjust the height, pull the lever (1)
and push the armrest to the desired
height. Afterwards make sure that the
lever (1) locks back into position. To
remove the sideguard completely,
push the lever (2). When fitting the
sideguard, the lever (2) must also be
pushed. Always make sure that the
sideguard locks into position correctly
in the receiver. (Fig.24)
Warning!
There is a danger of trapping your fingers when you adjusting the
armrest height.
The armpad position can be altered by opening the star knob (3)
and moving the pad into the desired position, (Fig.24).
Warning!
Make sure that the star knob is tightened correctly!
To increase the seat width by 2 cm the
inner pad can be removed and/or 2
spacers (1) added (Fig.25).
caution!
When spacing out the armrest the rear
wheel must be moved out too (Fig.25)
options – hemiplegic armrest
heMiplegic arMrest
The hemiplegic armrest can be
adjusted both in length and angle.
You can adjust the length by
pushing the armrest after having
loosened the 2 rotary screws (1).
To adjust the angle, open the
release lever (2) and rotate the
armrest to the desired position,
then tighten it again (Fig. 26).
options – anti-tip tubes
anti-tip tubes
Anti-tip tubes provide additional safety
for inexperienced users when they are
still learning how to operate their
wheelchair. They prevent a wheelchair
from tipping over backwards. The anti
tip tube should be inserted into the
frame tube until the first of the two
spring buttons enters the first hole in
the frame tube, (Fig.27).
Fig. 24
1
3
2
Fig. 25
1
Fig.26
1
2
Fig.27
Warning!
Incorrect setup of the anti-tips will increase the risk of a rearwards
tip. You must swing the anti-tips upwards when going up or down
large obstacles, (such as a kerb), to prevent them from touching the
ground, then rotate them back down to the normal position.
note: Do not insert both buttons of the anti tip tube into the frame
tube as this could damage the anti Tipp and cause a loss of
effectiveness. By pushing on the Second exposed release button,
the safety wheels can be set upwards or removed. There must
always be a gap of between 3 cm and 5 cm between the tube and
the ground. You must swing the safety wheels upwards when going
up and down large obstacles (such as a kerb) to prevent them from
touching the ground. Then rotate the safety wheels back down to
the normal position (Fig. 27).
options – lap belt
lap belt
danger!
Before using your wheelchair ensure the seat belt is worn and
correctly adjusted before use.
The lap belt is fitted to the
wheelchair as shown in the
illustrations. The seat belt
comprises 2 halves. They are fitted
using the existing seat stay
retaining bolt fitted through the
eyelet on the belt. The belt is routed
under the rear of the side panel.
(Fig. 28)
Adjust the belt position so buckles
are in the centre of the seat.
adjust lap belt to suit the user's needs as follows:
To increase the belt To reduce the belt
length
Feed free belt Feed free belt back
through slide adjust- through male buckle
ers and male buckle and slide adjusters.
to provide more belt
length.
Fig. 28
lenght
Ensure belt is not
looped at male
buckle.
RelaX
15
2