After Each Use - Craftsman 580.752870 Instrucciones De Uso

Ocultar thumbs Ver también para 580.752870:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

.
Check electrode gap with wire feeler gauge and reset
spark plug gap to recommended gap if necessary (see
@ecifications).
\
jr ...... ,.
.\
5.
Install spark plug and tighten firmly.
NOTICE You can purchase a new spark plug by calling
1-888-331-45££.
Inspect Muffler and Spark Arrestor
Inspect the muffler for cracks, corrosion, or other damage.
Removethe spark arrester, if equipped,and inspect for
damageor carbon blockage. If replacementparts are required,
make sure to use only original equipment replacementparts.
NOTICE To obtain a spark arrester screen, call
1-888-331-45££.
WARNINt
Exhaust heat/gases could ignite
combustibles, structures or damage fuel
tank causing a fire, resulting in death or
serious injury.
Contact with muffler area could cause burns resulting in
serious injury.
. DO NOTtouch hot pantsand AVOID hot exhaust gases.
o Allow equipment to cool before touching.
Keepat bast 5 ft. (1.5 m) of clearanceon all sides of pressure
washer including overhead.
o it is a violation of California PuNic Resource Code,Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrestor, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may havesimilar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark attester designed for the exhaust system
installed on this engine.
o Replacement pantsmust be the sameand installed in the same
position as the original pants.
Air Cooling System
Over time debris may accumulate in cylnder cooing fins
and cannot be observed without partial engine disassembly.
For this reason, we recommend you have a qualfied Sears
service dealer dean the cooing system per recommended
intervals (see MaintenanceSchedule). Equaly important is to
keep top of engine free from debris. See CleanDebris.
Carburetor Adjustment
The carburetor on this engine is low emission, it is equipped
with a non-adjustable idle mixture valve. Top speed has been
set at the factory, if adjustment is required, see an authorized
service dealer.
A CAUTION
Excessively high operating speeds could
result in minor injury.
Excessively low speeds impose a heavy load.
. DO NOTtamper with governor spring, Inks or other parts to
increaseengine speed. Pressure washer supplies correct rated
pressure and flow when running at governed speed.
o DO NOT modify pressure washer in any way.
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. Follow these procedures after every
use:
1.
Shut OFF(0) engine, turn off water supply, point gun in
a safe direction, press red button and squeezetrigger to
relievetrapped pressure and let engine cool.
_t_WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
o Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
, ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release high pressure, every
time youstop engine.
2.
Disconnect hose from spray gun and high pressure
outlet on pump. Drain water from hose, gun, and nozzle
extension. Use a rag to wipe off the hose.
3.
Empty pump of al pumped lquids by puling recol
handle about 6 times. This should remove most liquid in
pump.
4.
Col high pressure hose on hose wrap provided on
accessorytray.
5.
Store unit in a dean, dry area.
6.
if storing for more than 30 days see Long Term Storage
on next page.
A WARNING Fueland its vapors are extremelyflammable
and explosivewhich could causeburns,
fire or explosion resulting in death or
serious injury.
WHENSTORING FUELOREQUIPIVtENT
WITH FUELIN TANR
o Storeawayfrom furnaces, s toves,water heaters, c lothes
dryers,or otherappliances t hat havepilotlight or other ignition
sourcebecause theycouldignitefuel vapors.
22
Tabla de contenido
loading

Tabla de contenido