Craftsman 580.752870 Instrucciones De Uso página 24

Pump has following problems:
failure to producepressure,
erratic pressure, chattering, loss
of pressure, mow water vomume.
Detergent fails to mix with spray.
Enginewiii not start; starts and
runs roughor shuts down during
Cause Correction
1, Low pressure spray tip installed,
2, Water inlet is blocked,
3, inadequate water supply,
4, Inlet hose is kinked or leaking,
5, Clogged inlet hose screen.
6, Water supply is over 100%,
7, High pressure hose is blocked or
leaks,
8, Spray gun leaks,
9, Spray tip is obstructed.
10, Pump is faulty,
.
2.
3.
4.
Detergent siphoning tube is not
submerged.
Detergent siphoning tube is clogged
or cracked.
High pressure spray tip installed.
Detergent siphoning check ball
stuck.
1, Engine rocker switch set to OFF(0)
1. Replacewith high pressure spraytip.
2. Gearinlet.
3. Provide adequatewater flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose screen.
6. Provide cooler water supply.
7. Gear blocks in outlet hose.
8. Replacespraygun.
9. Cleanspray tip.
10, Contact Sears service facility.
.
2.
3.
4.
insert detergent siphoning tube into
detergent.
Cleanor replace detergent siphoning
tube.
Replacewith low pressure spray tip.
Freedetergent siphoning check ball.
1, Set engine rocker switch to ON (I)
operation.
position.
2. Low oil level.
3. Dirty air cleaner.
4. Out of fuel.
5. Stab fuel.
position.
2. Fill crankcase to proper level.
3, Cleanor replace air cleaner.
4. Fill fuel tank.
5. Drain fuel tank; fill with fresh fuel.
Engine lackspower.
6, Spark plug wire not connected to
spark plug,
7, Bad sparkplug,
8, Water in fuel,
9. Excessively rich fuel mixture.
Dirty air filter.
6, Connect wire to spark plug.
7, Replacesparkplug,
8, Drain fuel tank; fill with fresh fuel,
9, Contact local service facility,
Replaceair filter,
24