Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6
[AGC - ON/OFF] Auto-gain control switch
Setting this switch to "ON" automatically
increases the sensitivity even when the
brightness of the subject is insufficient.
(Default setting: ON)
[BLC - ON/OFF] Backlight
7
compensation switch
Setting this switch to "ON" opens the iris
even in backlight conditions, making the
subject easier to view.
(Default setting: OFF)
8
[AUTO/MANU] Auto/manual selection
switch
For selecting whether to adjust the white
balance automatically or manually.
(Default setting: AUTO)
9
[INT/LL] Synchronization system
selection switch
This switch sets the synchronizing
system for the camera.
INT:
This is set for internal synchronization
LL (Line Lock):
The camera's vertical synchronization is
locked to the AC 24 V power line fre-
quency.
When switching between multiple cam-
eras using a switcher, selecting this mode
and adjusting the vertical phase can re-
duce the monitor sync disturbances oc-
cur that when the camera image is
switched.
(Default setting: INT)
[WHT.BAL/PHASE] adjustment
10
selection switch
Switch to select the function of the
[R/B. +/–] adjustment button.
When setting to WHT.BAL:
When the
8
[AUTO/MANU] switch is
set to MANU, the white balance can
be adjusted using the [R/B, +/–] button.
When setting to PHASE:
When the
LL, the vertical phase of the line lock
can be adjusted using the [R/B, +/–]
button.
(Default setting: WHT.BAL)
11
[R/B, +/–] adjustment button
This button is pressed when manually
adjusting the white balance or when
adjusting the vertical phase of the line
lock.
The function of this button is selected
using the
10
When manually adjusting the white
balance:
Press the R button to increase the red
tint and decrease the blue tint.
Press the B button to increase the blue
tint and decrease the red tint.
When adjusting the phase:
Press the + or – button to adjust the
phase.
12
[RESET] Reset button
When this button is pressed, the value
of the white balance or phase adjusted
manually is reset to the default value.
When the
is set to WHT.BAL, the white balance is
reset to the default value. When the
switch is set to PHASE, the phase is
reset to the default value.
13
[SPOT CORRECTION] White-spot
correction button
11
When this button is pressed, white spots
are corrected.
For instructions on correcting white-
spots, see "About White-spot correction".
(
page 16)
9
[INT/LL] switch is set to
[WHT.BAL/PHASE] switch.
[WHT.BAL/PHASE] switch
10
E-7
Capítulos
Tabla de contenido
