Time-Setting Options; Kitchen Timer; Stopwatch; Automatic Safety Cut-Out - Siemens iQ500 ET475FYB1E Instrucciones De Uso

OTime-setting options
T here are 2 different time-setting options:
T i m e - s e t t i n g o p t i o n s

Kitchen timer

■

Stopwatch

■
Kitchen timer
You can use the kitchen timer to set a time of up to
99 minutes. It runs independently of all the other
settings.
Setting the kitchen timer
If the appliance is switched off, touch the
1.
once; if it is switched on, touch the
The indicator lights up.
V
display.
When the appliance is switched on, pressing
Note:
the 0 symbol once switches on the stopwatch.
Set the desired time in the settings range.
2.
The timer starts counting down after a few seconds.
When the time has elapsed
When the time has elapsed, an audible signal sounds
and ‹‹ flashes on the display for 10 seconds. The indicator flashes.
V
Touch any symbol.
The indicators go out and the audible signal ceases.
Setting the correct time
Use the symbol to select the kitchen timer and reset
0
the time.
Stopwatch
The stopwatch displays the time that has passed since
it was activated.
The stopwatch only works when the appliance is
switched on. When the appliance is switched off, the
stopwatch is switched off as well.
If the kitchen timer is selected in addition to the
Note:
stopwatch, the setting will appear on the timer display
for 10 seconds. The stopwatch will then be displayed
again.
Switching on
Touch the symbol.
0
1.
is shown on the display.
‹‹
Touch the control panel.
2.
Timing starts. Seconds are displayed during the first
minute, then minutes. After 10 seconds the timer
display goes out and the temperature is shown.
Touch the symbol to show the timer display
0
3.
again.
Switching off
Touch the symbol.
0
1.
The timer display will be shown.
Touch the control panel.
2.
The stopwatch will be switched off. The timer display
will go out.
symbol
0
symbol twice.
0
min lights up on the
‹‹
bAutomatic safety cut-out
I f an appliance has been switched on for a long time
A u t o m a t i c s a f e t y c u t - o u t
without the setting being changed, the automatic switch-
off is activated.
The appliance stops heating.
indicator / flash alternately on the display.
• œ
The indicator goes out when you touch any of the
controls. You can implement new settings.
When the time limit is activated depends on the
temperature selected (2 to 4 hours).

Time-setting options

" ‰ and the residual heat
en
11