Maintenance Schedule; Maintenance - Husqvarna R 213C Manual De Usuario

Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 16
Clean as given in
Clean the inner surface of the cutting deck, around the blades
Clean around the muffler
Make sure that the cold air intake of the engine is not blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Replace the engine oil
Replace the oil filter
Clean the air filter
Replace the air filter
Replace the fuel filter
Replace the spark plug
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
Lubricate according to the lubrication overview
854 - 003 - 14.11.2018
Maintenance
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance
before operation
*
*
X
X
X
X
X
*
X
X
X
Maintenance
interval in
hours
25 50 100
X
X X
X X
X
X X
X X
X
X
X
X
X X
X X
O O
15