Registering Am/Fm Radio Stations - Onkyo TX-8260 Manual De Instrucciones

> Before Start > Part Names

Registering AM/FM Radio stations

1
You can register up to 40 of your favorite
radio stations.
Registering
After tuning into the radio station you want
to register, perform the following
procedure.
1. Press MEMORY on the main unit so that
the preset number on the display
flashes.
FM 87.5 MHz 1
2. While the preset number is flashing
(about 8 seconds), repeatedly press the
cursor Left/Right buttons (b) on the
remote controller to select a number
between 1 and 40.
3. Press MEMORY again on the main unit
to register the station.
When the station is registered, the
preset number stops flashing. Repeat
this procedure for all of your favorite
24
> Install > Initial Setup
2
radio stations.
Selecting a Preset Radio Station
1. Press TUNER (a) on the remote
controller.
2. Press the cursor Left/Right buttons (b)
on the remote controller to select a
preset number.
Deleting a Preset Radio Station
1. Press TUNER (a) on the remote
controller.
2. Press the cursor Left/Right buttons (b)
on the remote controller to select the
preset number to delete.
3. While pressing MEMORY on the main
unit, press TUNING MODE to delete the
preset number. When deleted, the
number on the display goes off.
Registering Stations in the BGM
Buttons
You can register up to 4 of your favorite
> Playback
3
radio stations to the BGM buttons on the
main unit. By registering to BGM buttons,
you can start reception with one press of a
button.
After tuning into the radio station you want
to register, perform the following
procedure.
1. Press and hold one of the BGM buttons
1 to 4 on the main unit.
"Preset Written" is displayed on the
display and the station being received is
registered. If there is already a radio
station registered, it is replaced. Note
that the stations registered in BGM
buttons 1 to 4 are registered in preset
numbers 37 to 40 respectively.
0 Press the BGM buttons 1 to 4 to listen to
the stations you have preset. If you
press these buttons when the unit is in
standby mode, it comes on and starts
receiving the station.
Supplementary information | Advanced Setup | Others
a
b