GE JVM7195 Manual Del Propietário página 23

Care and cleaning of the microwave oven.
Convection Combinatio n Convection
Bake Fast Bake Roas t
Reheat
Defrost
Weight/Time
Cancel Start
Off Paus e
Lock Controls
Hold ٣ Sec
Timer Cook Set
On/Off Time Clock
Options Help
Turntable Surf ace Vent Fan
Light
Remove screw.
Popcorn Beverage Micr
Power
Warm Level
Convection Bake Combinatio n Convection
Fast Bake
Reheat
Defrost
Weight/Time
Cancel Start
Off Paus e
Lock Controls
Hold ٣ Sec
Timer Cook
On/Off Time
Options Help
Turntable Surf ace Vent Fan
Light
Charcoal filter
Popcorn Beverage Microwave
Express
Warm Power
Level
Convection Combination Convection
Bake Fast Bake
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook
On/Off Time
Options Help
Surface
Turntable Vent Fan
Light
Reusable vent filters
(on all models).
Popcorn Beverage
Power
Warm Level
Convection Combination
Bake Fast Bake
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook
On/Off Time
Options
Turntable Surface
Light
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.)
halogen bulb. Order WB08X10051 from your
GE Appliances supplier.
1. To replace the cooktop light/nite light, first
disconnect the power at the main fuse or
owav e
Expr ess circuit breaker panel, or pull the plug.
Aut o
Cook
Roas t Set
Clock
2. Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room
Auto
Cook also use a charcoal filter.
Roast
Set
Clock
Reusable Vent Filters
The metal filters trap grease released by foods
on the cooktop. They also prevent flames from
foods on the cooktop from damaging the inside
of the oven.
Removing and Cleaning the Filters
To remove, slide them to the rear using the
Microwave
Express
Auto
Cook
Convection
Roast
tabs. Pull down and out.
Set
Clock
Help
Vent Fan
To clean the vent filters, soak them and then
swish around in hot water and detergent. Don't
use ammonia or ammonia products because
they will darken the metal. Light brushing can
be used to remove embedded dirt.
3. Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4. Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
For this reason, the filters must always be in
place when the hood is used. The vent filters
should be cleaned once a month, or as needed.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots
on the back of each opening. Press up and to
the front to lock into place.
23