Remote Control Features; Setting Remote Control Codes - Yamaha YRS-2000 Manual De Instrucciones

In addition to controlling this unit, the remote control can also operate other AV components made by Yamaha and other
manufacturers. To control other components, you must set up the remote control with the appropriate remote control
codes and set the operation mode selector to TV/AV to change the control area.
Note
Depending on the external AV component you are using, you may not be able to operate the component with the remote control, even if
a remote control code is set. In this case, operate the component using the supplied remote control.

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area (STB, VCR, DVD, AUX, and TV).
For a complete list of available remote control codes, refer
to "List of remote control codes" at the end of this manual.
Transmission indicator
STB VCR
INPUT1
TV
AUTO
VOL MODE SETUP
5BEAM ST+3BEAM
1
STEREO
4
7
0
MUTE TV INPUT
1
Press and hold CODE SET and press one of
the input selector buttons to select the input
source you want to set a remote control code
for.
The transmission indicator flashes twice and remains
lit.
Proceed to step 2 while holding down CODE SET.
TV MUTE
While holding
down, press
CODE SET
Press and hold CODE SET until step 2 is
finished.

Remote control features

AV TV
DVD AUX
TV
INPUT2 MACRO
INPUTMODE SLEEP
3BEAM
2 3
MY SUR.
5 6
8 9
SUR. DECODE
+10
TV MUTE
CODE SET
STB VCR DVD AUX
TV
2
Press the numeric buttons to enter the
remote control code while holding down
CODE SET.
Setting example: Yamaha DVD input area
TV MUTE
While holding
down, press
CODE SET
Release CODE SET after entering the code.
3
Refer to "Controlling other components" on
page 72 to operate the external component
using the remote control.
If the external component functions correctly the
remote control code setup is successful.
If the external component does not function correctly,
the remote control code may be incorrect. Confirm
that the remote control code is correct. See "List of
remote control codes" at the end of this manual and
start over from step 1.
Note
If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
If the remote control is without batteries for more than
two minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries and reset the remote control codes.
When changing the batteries, be careful not to press
any of the buttons on the remote control. Doing so will
clear the contents of the memory.
Remote control features
MY SUR.
6
9
9
71
En